Install A Support Top - allen A-71101-EU Manual Del Usuario

Instructions for use
•
Retract—push the columns toward each other.
•
Extend—pull the columns away from each other.
9. When the cross tube is fully extended, lower
the handle to lock the cross tube into
position.
NOTE:
To lock the cross tube, it must be fully
extended.

Install a support top

WARNING:
Only use Allen support tops with the Allen® Advance Table, the
Mizuhosi® Flat Top, Rail Top or Orthopedic Top. Patient fall, injury,
or equipment damage could occur.
WARNING:
Use patient support tops that are designed for the simultaneous use of
tilt and Trendelenburg or Reverse Trendelenburg only. Otherwise,
patient fall, injury, or equipment damage could occur.
10. Make sure the patient support top is designed for the simultaneous use
of tilt and Trendelenburg or Reverse Trendelenburg.
11. Make sure the brakes on the Allen® Advance Table are
locked (the locked indicator on the Allen® Advance
Table display is green).
12. If the lower H-brackets are not installed on
each end of the Table, proceed as shown
below. Otherwise, go to Step 13.
a. Hold the H-bracket so that the
open end is down, the J ends are
toward you, and the bracket is
angled toward you.
24 Allen® Advance Table User Guide (D-720722 Ver D)