Finish Assembly; Description Of Controls - Honda HRE330A2 Manual De Instrucciones

3. FINISH ASSEMBLY

WARNING!
Unpacking and completing the assembly
should be done on a flat and stable surface, with enough space
for machine handling and its packaging, always making use
of suitable equipment.
Disposal of the packaging should be done in accordance with the
local regulations in force.
Fit the two sleeves (1) to the two lower parts of the handle (2) and
(3), positioning them so that the openings are facing towards the in-
side, then tighten the screws (short) (4), provided in the pack.
Insert the right (2)
and left (3) parts of
the handle into the
respective holes,
making sure the
positions have not
been inverted; now
fasten them in
place using the
screws (long) (5)
supplied in the
pack.
Tightening
4
torque: 3,0 Nm.
Apply the two caps
(6) to then ends of
the upper part of
the handle (7).
Attach the upper
part of the handle
(7) to the lower
parts using the
5
knobs (8) and the
nuts and bolts sup-
plied as shown.
Use the supplied clamp (9) to fasten the cable (10) in the indicated
position.
Insert the frame (1)
into the sack (2) and
attach all the plastic
profiles (3) with the
help of a screwdriver,
as shown in the
drawing.
EN 4
7
8
10
6
9
4
2
5
1
1
1

4. DESCRIPTION OF CONTROLS

The motor is controlled by a
dual action switch to prevent
starting it accidentally.
To start, press the button (2)
and pull the lever (1).
The motor
stops on releasing the lever
(1).
• HRE 330
The cutting height is adjusted by attaching the wheels to the required
hole, fully tightening the pin (1) using the wrench (2) provided.
All the wheels must be at the same height.
6
MAKE THIS ADJUSTMENT ONLY WHEN THE BLADE IS
STOPPED.
3
4
1
• HRE 370
The height is adjusted using the special lever (1).
MAKE THIS ADJUSTMENT ONLY WHEN THE BLADE IS
STOPPED.
automatically
Ø 130
1
1
Ø 160
1
2