Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CONNECTING
THE INLET HOSE
The dryer must be connected to the cold water tap
using the new water supply hose. Do not use old hoses.
NOTE:
• Water supply pressure must be between 21.8 PSI and
116 PSi (150-800
kPa).
• Do not strip or cross-thread when connecting
inlet hose
to the valve.
• If the water supply pressure is more than 116 PSi (800
kPa), a pressure reducing
valve should be installed.
• Periodically
check the condition
of the hose and
replace the hose if necessary.
• Replace inlet hoses after 5 years of use to reduce the
risk of hose failure.
• Record hose installation
or replacement
dates on the
hoses for future reference.
1. Check the rubber seat in the inlet hose. Two rubber
seals are supplied with each inlet hose. They are used
for preventing water leaks. Make sure the connection
to the cold water tap is tight.
I
Hose
connector
_
Rubbe_
seal
Y connector
2. Check the installation
type.
I
s_--Short
....
m_ _
hose
_
Yconnector
I
Long ....
hose
WITH WASHER
WITHOUT WASHER
Connect all water supply hoses tightly
by hand and
then tighten another 2/3 turn with pliers.
WITH WASHER: When connecting
the dryer to the same
faucet as a washer.
a. Shut off the cold water tap and remove the washer
hose.
b. Connect the short hose to the Y-conncetor
using one
of the hose washers.
c. Connect the other end of the short hose to the cold
water faucet.
d. Connect the long dryer hose to one side of theY-con-
nector and connect the washer hose to the other side.
WITHOUT
WASHER: If the dryer does not share the
cold water tap with a washer.
a. Connect the straight
end of the long hose to the cold
water faucet.
NOTE:
• Before connecting
the water line to the dryer, flush
several gallons of water into a drain or bucket. This
will help prevent foreign
particles
such as sand and
scale from cloggong
the dryer inlet valve.
• Do not overtighten.
Damage
to the coupling
can
result.
.
®
Connect the hose to the dryer.
Connect
the water
supply
hose to the dryer
inlet
valve
tightly
by hand
and then
tighten
another
2/3
turn with
pliers.
Make
sure that
there
are no kinks in
the hoses and that
they are not crushed.
4. Turn on the cold water faucet.
5. Check for leaks at the Y-connector
(if used) and all
hoses.
I
I
NOTE:
• If any leaks are found, shut off the water faucet,
remove the hose and check the condition
of the hose
washer.
16
Tabla de contenido
