Tabla de contenido
Idiomas disponibles
Idiomas disponibles
VENTING
THE DRYER (continued)
Routing
and Connecting
Ductwork
Follow the guidelines
below to maximize
dryer
performance
and reduce lint buildup and condensation
in the ductwork.
NOTE: Transition duct and fittings are NOT included
and must be purchased separately.
* Use 4 inch (102mm) diameter
rigid or semi-rigid
metal duct.
* The exhaust duct run should be as short as possible.
* Use as few elbow joints as possible.
*The male end of each section of exhaust duct must
point away from the dryer.
* Use duct tape on all joints. Never use screws.
* Insulate ducts that runs through unheated
areas in
order to reduce condensation
and lint buildup
on
duct surfaces.
* The total length of semi-rigid
metal transition
duct
should not exceed 8 ft. (2.4 m).
WARNING:
Failure to follow these
guidelines wilt result in poor performance,
product
failure, and/or
result in fire or death.
IMPORTANT:
Failure
to exhaust
the dryer,
per the
guidelines
included
within
these
instructions,
may
result
in unsatisfactory
dryer
performance.
All venting
and
ductwark
beyond
the exterior
of the dryer
is the
responsibility
of the consumer.
Product
failure,
as
a result
of improper
venting,
is not covered
by the
manufacturer's
warranty.
Connecting
the
Dryer
Vent
O
Verify all ducts and elbows are clean and free
from any blockages.
Measure duct length. DO NOT exceed the
maximum
length listed in the Duct Length Chart.
Connect dryer exhaust to existing duct.
* Only use duct tape or clamps.
DO NOT use screws to secure ductwork.
Use rigid or semi-rigid
metal ducts.
DO NOT use plastic or thin metal foil tubing
for ductwork.
The male end of each elbow must always point in
the direction of the airflow.
NOTE: Be careful when moving the dryer into its
final location.
Do NOT crush the duct. Make sure the
connections do not come loose.
incorrect
Venting
Male
l
Ends
,_
O
15
Tabla de contenido
