Safety Instructions; Electrical Safety - PYD Electrobombas XKS Serie Manual De Instalación Y Mantenimiento

OPERATING AND MAINTENANCE MANUAL
SERIE XKS

2. SAFETY INSTRUCTIONS

Electrical safety:

DANGER! Electric shock!
Before starting up the pump make sure that:
- The pump must not be used when people are in the water.
- Make sure that the electrica| plug and socket connections are fitted in an area which cannot flood.
And protect power plug from moisure.
- Check out if there is any damage to the pump, especially to the cable and plug. A damaged pump
mustn't be used any way.
- The pump must be supplied through a residual current device (RCD) having a raled residual opera-
ting current not exceeding 30 mA.
- The mains supply voltage matches the voltage indicated on the pump identification plate.
Attention to your operating:
- Never carry the pump by its cable and do not pull the cable to disconnect it. For submerging, lifting
or securing the pump, fix a rope to the pump's carrying handle is the correct choice.
- Do not pull out the power cable from the socket as a method of turning the pump
- Check out if the outlet and the inlet of the pump clog. Clear the oudet and the inlet when need.
Automatic protection for safety:
- Thermal molor protector: The pump is automatically switched off on overheating by the built-in
therma| motor protector. After having cooled down the motor automatically switches on again.
- Automatic Air bleed valve: The automatic air bleed va|ve eliminates any air pockets in the pump.
Note: The position of vent hole may be different in some models.
Main power cables must not have a smaller cross-section than the rubber-shealhed cables of the
designation H05RN-F while the pump without power cable lighter than 5kg and the designation
H07RN-F while the pump without power cable heavier than 5kg.
Tha cable lenght must be at leat 10m.
www.proindecsa.com / [email protected]
During this process, air escapes through the plastic plug on the
pump and air bubbles appear underwaler, This is not a defect of
your pump, but serves to deaerate the pump, but serves to remove
air from the pump. It may tahe several seconds for the air to esca-
pe when the pump is immersed for the first time.
6