For Safe Operation - PAPILLON Ranger 25 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Ranger 25 - 92831

1. For safe operation

1.
Never operate a saw when you
are fatigued, ill, or upset, or
under
medication that may make you
drowsy, or if you are under the
influence of alcohol or drugs.
2.
Use safety footwear, snug fitting
clothing and eye, hearing and
head protection devices.
3.
Always use caution when hand-
ling fuel. Wipe up all spills and
then move the chain saw at least
3m from the fueling point before
starting the engine.
3a. Eliminate all sources of
3b.
4.
Do not allow other persons to be
near
starting
bystanders
minimum of 10m away when you
start of operate the chain saw.
5.
Never start cutting until you have
a clear work area, secure footing,
and a planned retreat path from
the falling tree.
6.
Always hold the chain saw firmly
with both hands when the
engine is running. Use a firm
grip with thumb and fingers
encircling
handles.
the
influence
sparks
or
flame
smoking, open flames, or
work
that
can
sparks)in the areas where
fuel is mixed, poured, or
stored.
Do
not
smoke
handling
fuel
or
operating the chain saw.
the
chain
saw
or
cutting.
sho-
uld
the
chain
of
(i.e.
cause
while
while
when
Keep
be
a
saw
18
7.
Keep all parts of your body away
from the saw chain when the
engine is running.
8.
Before you start the engine,
make sure the saw chain is not
contacting anything.
9.
Always carry the chain saw with
the engine stopped, the guide
bar and saw chain to the rear,
and the muffler away from your
body.
10. Always inspect the chain saw be-
fore each use for worn, loose, of
damaged parts. Never operate a
chain saw that is damaged, im-
properly adjusted, or is not com-
pletely and securely assembled.
Be sure that the saw chain stops
moving when the throttle control
trigger is released.
11. All chain saw service, other than
the items listed in the Owner's
Manual, should be performed by
competent chain saw service
personnel.(E.g., if improper tools
are used to remove the flywheel,
or if an improper tool is used to
hold the flywheel in order to re-
move the clutch, structural dam-
age to the flywheel in order to re-
move the clutch, structural dam-
age to the flywheel could occur
which could subsequently cause
the flywheel to disintegrate.)
12. Always shut off the engine be-
fore setting it down.
13. Use extreme caution when cut-
ting small size brush and sap-
lings because slender material
may catch the saw chain and be
whipped toward you or pull you
off balance.
14. When cutting a limb that is un-
der tension, be alert for spring
back so that you will not be
struck when the tension in the
Tabla de contenido
loading

Tabla de contenido