Date & Time Set Procedure; Applying The Cuff - HoMedics THERA-P BPW-200 Manual Del Usuario

DATE & TIME SET PROCEDURE
1. To adjust the date/time, press the Set
button located on top of the monitor.
The display will show a blinking number
showing the hour.
2. Change the hour by pressing the
button. Each press will increase the
number by one in a cycling manner.
Press the Set button
entry, and the screen will show a blinking
number representing the minutes.
3. Change the time and date as described
in Step 2 above, using the
change the numbers and the Set button
to confirm the entries.
4. A "0" will reappear as the blood pressure
monitor is ready for measurement again.
repeat process to set time and date
again to confirm the
button to
Press the button
blinking hour
increasing hour
confirm the entry
15

APPLYING THE CUFF

1. Remove all watches,
wrist jewelry, etc. prior
to attaching the wrist
monitor. Clothing
sleeves should be rolled
up and the cuff should
be wrapped around
bare skin for correct
measurements.
2. Apply cuff to left wrist
with palm facing up as
shown in Fig. A.
3. Make sure the edge
of the cuff is about
1/4"~1/2" (1 cm) from
the palm as shown
in Fig. B.
Fig. A
Fig. B
16