Correct Operation - Phcbi MCO-170M Instrucciones De Operación

CORRECT OPERATION

Use the following procedure to start trial operation or actual operation of the incubator.
1. Install the incubator correctly, referring to pages 18–23.
2. Remove the packing materials from the chamber and inner attachments. Clean and disinfect the
chamber and all the inner attachments, referring to page 24.
3. Add approximately 1.5 L of sterile distilled water to the humidifying pan. (Refer to page 29.)
4. Connect the removable power supply cord to the port on the lower right side.
Note: Two removable power supply cords are provided.
5. Connect the removable power supply cord to the outlet.
6. Turn ON the power switch on the lower right side of the incubator.
7. (When an optional UV system set MCO-170UVS is installed) Set the frequency of power supply on the
LCD touch panel (Refer to page 54).
The removable power supply cord provided is only for this product. Never use it for any other products.
32
For UK For EU countries other than UK