FIC K8M-800T/M Manual página 41

UART Mode Select
This allows you to select the IR modes if the serial port 2 is used as an IR
port. Set at Normal, if you use COM2 as the serial port, instead of as an IR
port. The options are: Normal, IrDA, ASKIR, SCR.
UR2 Duplex Mode
This allows you to select the IR modes. The options are: Full, Half.
Onboard Parallel Port
Allows you to select from a given set of parameters if the parallel port uses
the onboard I/O controller.
The options are: Disabled, 378/IRQ7, 278/IRQ5, 3BC/IRQ7.
Parallel Port Mode
Allows you to connect with an advanced printer via the port mode it sup-
ports. The options are: SPP, ECP, EPP, EPP+ECP.
ECP Mode Use DMA
This feature allows you to select Direct Memory Access (DMA) channel.
The options are: 1, 3.
Onboard Lan Device
This allows you to disable onboard LAN feature.
The options are: Enabled, Disabled.
Onboard Lan Boot ROM
Enables and disables the onboard LAN Boot ROM.
The options are: Enabled, Disabled.
Onboard 1394 Device
This allows you to disable the onboard 1394 feature.
The options are: Enabled, Disabled.
BIOS Setup
3 - 13