Set System Jumpers; Clear Cmos; Led Type Select - FIC K8M-800T/M Manual

K8M-800T/M Mainboard Manual

1.) Set System Jumpers

Clear CMOS

The CMOS RAM is powered by the onboard button cell battery.
To clear the RTC data:
(1) Turn off your computer;
(2) Open the system case and disconnect the ATX power cable;
(3) Place the jumper cap onto the pinpair 2-3 for at least 6 seconds
to enable CMOS clearance;
(4) Place the jumper cap onto the pinpair 1-2 to disable the effect of
CMOS clearance;
(5) Connect the ATX power cable and close the system case;
(6) Turn on your computer until CMOS checksum error appears;
(7) Hold down the Delete key when booting;
(8) Enter the BIOS Setup to re-enter user preferences.

LED Type Select

This 2x3 jumper allow you to select Power LED Type, single LED or dual
LED.
2 - 2