Porter Cable PCE700 Manual De Instrucciones página 6

TO CARRY
Fold down unit to position where you can carry the saw. Hook
lock to lock arm down.
UNLOCKING
To unlock tool and raise head, depress motor arm slightly and
unhook lock out. Motor arm will then pivot upward.
SPARK DEFLECTOR ADJUSTMENT (FIG. b)
To best deflect sparks away from surrounding persons and
materials, loosen the screw (1a), adjust the spark deflector (1)
and then retighten screw. Do not allow cordset to come into
contact with deflector or sparks as damage to cordset may occur.
DEPTH STOP (FIG. C)
Depth stop is set at the factory for a new 14 inch (355mm)
wheel to prevent wheel from cutting into the supporting
surface. To allow more depth of cut, use the wrench (5) to
loosen the depth stop bolt (11) and lower bolt to desired height.
Then, turn jam nut (11) clockwise until seated firmly on the
casting. Securely tighten the depth stop bolt before use.
CAUTION:
When changing to a new wheel, readjust depth
stop to original position to prevent cutting into supporting surface.
TRIGGER SWITCH (FIG. D)
To start the tool, depress the trigger switch (12). To turn the
tool off, release the trigger switch. Keep hands and material
from wheel until it has coasted to a stop.To prevent
unauthorized use of tool, install a standard padlock
(not included) into the padlock hole (13) located in
the trigger.
MATERIAL CLAMPING AND SUPPORTING (FIG. E, F)
• Angled material is best clamped and cut with
both legs resting against base.
• A spacer block slightly narrower than the
workpiece can be used to increase wheel
utilization (Fig. E).
• Long workpieces must be supported by a block
so it will be level with top of base (Fig. F). The
cut off end should be free to fall downward
avoid wheel binding.
VISE OPERATION (FIG. G)
The vise (4) has a quick-travel feature. To release
vise when it is clamped tightly, turn the crank
counterclockwise one or two times to remove
clamping pressure. Lift vise lever (7) up.
crank assembly out as far as desired. Vise may be
pushed forward into work without cranking. Lower
lever then tighten vise on work by using crank.
G
4
7
6
DIAMETER OF WORKPIECE
E
4
WIDTH OF SPACER BLOCK
F
BLOCK
6
b
1a
C
11
D
13
12
SPACER BLOCK
CUT-OFF END
1
to
the
(6)
Pull
vise