Solving Problems - Lacor 69192 Instrucciones De Uso Y Mantenimiento

Problems
Machine does not work
Water temperature does not
increase
Water goes on heating after the
set temperature is reached.
E01 appears on the display.
Machine plugs in and turns on, but
no display in the LCD.
The pump is noisy
36

SOLVING PROBLEMS

Raisons
1.- Power cord is not plugged
in well.
2.- Power button is off.
3.- Problem from the power
supply.
1.- Set temperature below or
close to the water
temperature.
2.- Set heating time is too short.
1.- Program is wrong.
2.- Temperature sensor is invalid.
3.- The circulator does not rotate.
1.- Machine does not be put into
water.
2.- Water level is too low.
1.- Power button is off.
2.- The thermic overload is cut
off.
3.- Machine is wrong.
1.- Air in pump
2.- Dirt in the pump
Solution
1.- Plug in, turn on the machine.
2.- Turn on the power switch.
3.- Check if the other Machines
work normally.
1.- Check the setting.
2.- Prolong the heating time.
1.- Restart the power switch.
2.- Repaired by the specialist.
3.- Repaired by the specialist.
1.- Put the machine into water
and restart the power switch.
2.- Add water, make sure the
water level is between the
MIN and MAX line.
1.- Turn on the power switch.
2.- Open the plastic cover in
the front of the machine, press
"Reset" button.
3.- Repaired by the specialist
1.- After filling the tank, shake
several times the machine
to air out through the propeller
pump.
2.- Clean the machine and the
pump as instructed in the
manual chapter Cleaning or
ask a specialist to clean them.