Printing Language Change Mode - Terragene IC10FR Manual Del Usuario

Instructions for use
- Hours setting: Ten hours (Hh:mm)
The blue light number 1 corresponding to PRO sector should be
on. If any other light from PRO sector is on, press
button as many times as necessary to turn on the blue light
number 1. This indicates ten hour setting.
To increase ten hours value, press button
hours value, press button.
NOTE: the possible values for ten hour are 0, 1 and 2.
- Hours setting: Unit hours (hH:mm)
Press button to turn on the blue light number 2. This
indicates unit hours setting. If any other light from PRO sector is
on, press button as many times as necessary to turn
on the blue light number 2.
To increase unit hours value, press
hours value, press button.
Minutes setting
- Minutes setting: Ten minutes (hh:Mm)
Press button to turn on the blue light number 3. This
indicates ten minutes setting. If any other light from PRO sector
is on, press button as many times as necessary to turn
on the blue light number 3.
To increase ten minutes value, press
ten minutes value, press button.
NOTE: possible values for ten minutes are 0, 1, 2, 3, 4 and 5.
- Minutes setting: Unit minutes (hh:mM)
Press
indicates unit minutes setting. If any other light from Pro sector
is on, press
turn on the blue light number 4.
. To reduce ten
button. To decrease unit
button. To decrease
IC10/20FR Page 12
button to turn on the blue light number 4. This
button as many times as necessary to
To increase unit minutes value, press button.
unit minutes value, press button.
Finish hours setting
To save changes press and hol-
4) for three seconds. A beep will sound, PRO green light will turn
on and a ticket with the new set time will be printed to indicate
the procedure has been completed successfully.
NOTE: If the modification has not been done correctly,
the auto-reader will emit 3 beeps and the red light from
PRO sector will turn on. Repeat the procedure.
Cancel hours setting
To cancel hours setting procedure without saving the changes,
disconnect power source.

Printing language change mode

This function allows you to change the auto-reader printing
language.
NOTE: each language has a code number assigned:
1: English | 2: Spanish | 3: Portuguese | 4: Turkish
Enter to Printing language change mode
De-energize the auto-reader.
Press and hold button and energize the equipment. A
sound will be emitted to indicate Access to Printing
language change mode.
To decrease
dzbutton (see Figure