Bosch Mastertech II VCI Instrucciones De Manejo página 12

en | 12 | Mastertech II VCI
5.4.1 Activating the WLAN link via an
access point
The Mastertech II VCI can be configured to
connect via an access point. The following
must be prepared before configuring:
•
An IP address and subnet mask that can
be assigned to the Mastertech II VCI
(if the existing LAN does not assign IP
addresses automatially)
•
A wireless network access point SSID
(network name)
•
Network security standard WPA2 enabled
•
Data encryption via TKIP or WEP (64-bit
or 128-bit)
•
WLAN password
The figure below shows several
Mastertech II VCIs that are connected to a
single computer via a wirelss access point.
Use the following procedure to configure
your Mastertech II VCI for a wirelss connec-
tion in your network environment. Contact
your IT administrator before starting setup.
1. Double-click the VCI Manager icon on
your desktop to launch the "VCI Manager"
software.
2. Plug the Mastertech II VCI into an exter-
nal 12V power source.
3. Plug the USB connecting cable into the
computer and Mastertech II VCI and al-
low Mastertech II VCI to boot completely.
4. Connect to your Mastertech II VCI in the
VCI Manager software.
5. Select the "Network Setup" tab.
1699200881 | 2020.03.02
6. In the "Wireless (802.11)" tab, select the
option "Activate wireless interface"
ΠThe "IP address configuration" input
field becomes active.
7. Select the option "Automatic assignment
of IP address" if your network assigns IP
addresses automatically.
i
If your network uses fixed IP addresses,
your IT administrator will assign the IP
address and subnet mask.
8. Select <Access Point>.
9. Assign network name:
$
If the network uses a hidden SSID or
is not within range, the network name
can be enter via the option "Enter
network name (SSID)".
$
If the network is within range, the
network can be selected via the
option "Select from list of available
networks". Press <Update> to have the
Mastertech II VCI search for available
WLAN signals.
10. After the network name has been entered,
continue with <Configure>.
11. Enter the security settings for the network
and select <Next>.
12. Select <Yes> to configure the
Mastertech II VCI again, or <No> to cancel
the procedure.
13. Select the "Settings" tab and check that
the Mastertech II VCI was configured
correctly.
i
By disconnecting the USB connection,
you can check whether configuration was
successful.
14. Back up the settings for future
Bosch Automotive Service Solutions, Inc.
changes.