Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1. PREPARE THE INSTALLATION
Make sure that the following items are included:
- Hood
- Hood mounting bracket (taped inside the hood)
- 10" round adapter (taped inside the hood)
- Installation manual
- Bag of parts including: 1 wire clamp, 3 waterproof wire connectors, 14 no. 10-12 x 2½" screws, 4 no. 8-18 x 3/8" screws, 10 washers,
1 suction cup (contains more parts than required to perform the installation). (Taped inside the hood.)
Parts sold separately:
- Blower assembly model P12NA
- Decorative flue:
- Part no. AEWTD915SB for ceilings 8' to 8.5' high
- Part no. AEWTD1629SB for ceilings 8.5' to 9.5' high
- Part no. AEWTD3057SB for ceilings 9.5' to 12' high
2. INSTALL THE DUCTWORK AND ELECTRICAL WIRING
When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
This range hood is not designed for use with a charcoal grill.
This range hood is intended for outdoor covered patio or lanai area. As with all electric appliances, this unit must
be protected from the effects of weather.
These range hoods must be installed with the P12NA blower (sold separately). Do not substitute for an other blower.
Plan where and how the ductwork will be installed. A straight, short duct run will allow the hood to perform most efficiently. Refer to
illustrations below to locate duct opening.
Install 10-inch ductwork, elbows (if needed) and roof or wall cap. Connect metal ductwork to the cap and work back towards the hood
location. Use 2" metal foil duct tape to seal the joints.
The power cable must be a GFCI protected branch circuit.
Run 3-wire power supply cable to installation location.
The hood must be installed at least 36'' above the cooking surface.
ROOF CAP
WALL
CAP
36" ABOVE COOKING SURFACE
HH0275A
WARNING
!
CAUTION
WARNING
!
10" ROUND DUCT
10" ROUND ELBOW
HOOD
HK0282A
3
C L
17 15/16" (36" hood)
20 15/16" (42" hood)
23 15/16" (48" hood)
6 1/4"
30"
Tabla de contenido
