Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Review this table to oQG do-it-yourself solutions for minor performance problems. Any other
service needed should be performed by a Sears or other TXDOLoHG service agent.
WARNING
$OZD\V WXUQ Rç DQG XQSOXJ YDFXXP FOHDQHU before performing maintenance to the
vacuum cleaner. Failure to do so could result in electrical shock or personal injury.
PROBLEM
Vacuum cleaner won't
start.
Poor job of dirt
pick-up
Vacuum cleaner starts
but shuts oç.
®
PowerMate
will not
run when attached.
TROUBLESHOOTING
POSSIBLE CAUSE
1.
Unplugged at wall outlet.
2.
Tripped circuit breaker/
blown fuse at household
service panel.
3.
Loose hose electrical
connections.
Full or clogged dust bag.
1.
2.
&ORJJHG DLUpRZ SDVVDJHV
3.
'LUW\ oOWHUV
4.
Wrong pile height setting.
5.
Wrong power level selected.
6.
Hole in hose.
®
7.
Worn PowerMate
agitator.
8.
Worn or broken belt.
Dirty agitator or end caps.
9.
10.
Canister hood open.
11.
Tripped overload protector
®
in PowerMate
.
Hose or hood electrical
1.
connections.
2.
Tripped overload protector
®
in PowerMate
.
3.
Tripped thermal protector
in canister.
®
1.
PowerMate
connections
unplugged.
2.
Worn or broken belt.
3.
Dirty agitator or end caps.
Tripped overload protector
4.
®
in PowerMate
.
5.
Vacuum cleaner in
HARDFLOOR mode.
- 23 -
POSSIBLE SOLUTION
1.
Plug in oUPOy, press ON/OFF switch.
2.
Reset circuit breaker or replace fuse.
3.
Reconnect hose ends.
Change bag.
1.
2.
Clear DLUpow passages.
3.
Clean/change oOWHUV
4.
Adjust setting.
5.
Adjust control.
6.
Replace hose.
7.
Change agitator.
8&9.
See BELT CHANGING AND
AGITATOR CLEANING (page 20).
10.
Close and latch hood.
11.
Remove any items that may be
caught or jammed, then reset. If
vacuum cleaner starts and stops again,
clean agitator and end caps, then reset.
Check connections, reconnect hose
1.
ends.
2.
Remove any items that may be
caught or jammed, then reset. If
vacuum cleaner starts and stops
again, clean agitator and end caps,
then reset.
3.
See PERFORMANCE/SAFETY
FEATURES – "Thermal Protector"
(page 15).
1.
Plug in oUPOy.
2&3.
See BELT CHANGING AND
4.
AGITATOR CLEANING (page 20).
Remove any items that may be
caught or jammed, then reset. If
vacuum cleaner starts and stops
again, clean agitator and end caps,
then reset.
Press CARPET button to activate
5.
®
PowerMate
.
Capítulos
Tabla de contenido
