Troubleshooting; Environmental Information - Husqvarna Weed Eater Manual Del Operador

20” eléctrico a rotativo segadora
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

PROBLEM
Handle not in position
Mower not starting.
Mower cutting unevenly.
Mower not mulching
properly.
Mower hard to push.
Mower vibrating at
higher speed.
SERVICE RECOMENDATIONS
• Your product is uniquely identified with a model and serial number on a label attached to your product.
• We strongly recommend that your product is serviced at least every twelve months, more often in a
professional application.

ENVIRONMENTAL INFORMATION

• Awareness of the environment must be considered
when disposing of 'end-of-life' product.
• If necessary, contact your local authority for disposal
information.
By ensuring this product is disposed of correctly, you will
help prevent potential negative consequences for the
environment and human health, which could otherwise be
caused by inappropriate waste handling of this product. For
POSSIBLE CAUSE
Carriage bolts not seated properly.
Handle knobs not tightened.
Extension cord not connected to
the mower plug.
Extension cord not connected to
power source.
Motor control switch defective.
Lawn is rough or uneven or
height not set properly.
Wet grass clipping sticking to
the underside of the deck.
High grass, rear of mower
housing and blade dragging in
heavy grass, or cutting height
too low.
Blade is unbalanced.
Bent motor shaft.
ENGLISH - 12
SOLUTION
Adjust the height of the handle
and make sure the carriage bolts
are seated properly
Tighten handle knobs.
Reconnect the cord and use the
cord retainer to keep the cord
close to the motor/blade control.
Connect to power source
Have motor control switch
replaced by an authorized service
center.
Move the wheels to a higher
position. All wheels must be
placed in the same cutting height
for the mower to cut evenly.
Wait until the grass dries before
mowing.
Raise cutting height.
Balance the blade by grinding
each cutting edge equally.
Stop the motor, disconnect the
power source, and inspect for
damage. Have repaired by an
authorised service center before
restarting.
more detailed information about recycling of this product,
please contact your local council office, your household
waste disposal service or the shop where you purchased
the product.
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Weedeater

Tabla de contenido