To Lubricate The Cutting Deck Spindles; To Lubricate The Front Wheels; Troubleshooting; Troubleshooting Schedule - Husqvarna Z246 Manual De Usuario

Refer to Lubrication
C Lubricate the grease nipple with a grease gun.
D Do a check of the oil level.
E Replace the oil filter.
Always use good quality grease. Always use
recommended oil, refer to
26 .

To lubricate the front wheels

• Grease the nipple (A) with a grease gun until
grease comes out from the top washer.
A
• Lubricate the joint bearing of the front wheels (B)
with a grease gun until grease comes out.

Troubleshooting schedule

If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem
Engine does not start.
22
Technical data on page
B

Troubleshooting

Cause
The drive of the blades is engaged. Refer to
Off) button on page 4 .
The control levers are not locked in the outer position.
The battery is too weak. Refer to
17 .
There is dirt in the carburetor or the fuel line.
The fuel shut-off valve is closed or in the incorrect position.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
Interval
Each 25
Yearly
hours
X
X
To lubricate the cutting deck
spindles
1. Set the cutting deck in mow position.
2. Lubricate each cutting deck spindle 2-3 strokes.
Note:
Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
To charge the battery on page
Each 50 Each 200
hours hours
X
PTO (Power Take-
1550 - 002 - 08.12.2022