Features; Technical Data - Surtek PHI12 Manual Del Usuario

• Do not use the shop press unless it is properly
lubricated.
• Using a shop press that is not in good clean
working condition or properly lubricated may
cause serious injury.
• Inspect the work area before each use. Make
sure it is free and clear of any potential hazards.
DO NOT OPERATE OR REPAIR THIS EQUIPMENT
WITH OUR READING THIS MANUAL
To maintain the Shop Press and user safety, the
responsibility of the owner is to read and fol-
low these instructions. Inspect the service shop
press for proper operation and function. Keep
instructions readily available for equipment op-
erators. Make certain all equipment operators
are properly trained; understand how to safely
and correctly operate the unit. Allow unit oper-
ation only with all parts in place and operating
properly. Use only genuine replacement parts.
Service and maintain the unit only with autho-
rized or approved replacement parts negligence
will make the shop press unsafe for use and
void the warranty. Carefully inspect the unit on
a regular basis and perform all maintenance as
required. Store these instructions in the handle
of your shop press. Keep all decals on the unit
clean and visible.
SAFETY: always follow safety precautions when
installing and operating this shop press. Keep
all decals on the unit clean and visible. Before
proceeding that you fully understand and com-
prehend the full contents of this manual. Fail-
ure to operate this equipment as directed may
cause injury or death. The distributor is not re-
sponsible for any damages or injury caused by
improper use or neglect.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.

TECHNICAL DATA

PHI12
CAPACITY
WORK RANGE
STROKE LENGTH
TABLE WIDTH
EXTERNAL WIDTH
PHI20
CAPACITY
WORK RANGE
STROKE LENGTH
TABLE WIDTH
EXTERNAL WIDTH
12 t (24 000 lb)
(0 - 69,5) cm
14 cm (5-1/2")
40 cm
53 cm
20 t (40 000 lb)
(0 - 75) cm
18 cm (7")
50 cm
65 cm
E N G L I S H •
PHI30
CAPACITY
WORK RANGE
STROKE LENGTH
TABLE WIDTH
EXTERNAL WIDTH
ASSEMBLY
1. Attached rail sections (13) to left and right
posts and lower cross member (19) using bolts
(9), washers (10), lock washers (11) and nuts (12).
2. Put the press frame in an upright position,
attach upper cross beam (14) to left and right
posts (5) using bolts (1), washer (2), lock wash-
er (3) and nuts (4). (Hook mounts should face
down on upper cross beam.
3. Put the frame in an
upright position, and
attach the upper cross
beam (14) and attached
the springs (15). Then
attach eye hooks (17),
using nuts (20) to mid-
dle bolster (18). The at-
tach springs to middle
bolster. (Middle Bolster
will then suspend be-
tween left and right
frame posts.)
U s er 's M an u al
30 t (60 000 lb)
(0 - 80) cm
20 cm (7-7/8")
53 cm
66 cm
11