Electric system
1. DASHBOARD PROGRAMMING
DASHBOARD
The insertion of Values in the Display is carried out through the button "Trip" placed in the
left side of the Handlebar.
In the Model MRX and MRX PRO the insertion of values will be carried out with the engine
running.
In the Model SMX and SMX PRO the Battery is connected and loaded, so it can be carried
out with the key in the ignition position and also with the engine running.
INSERTION OF THE VALUES OF CALCULATION IN THE ODOMETER
MEMORY
• Development of the wheel that sets the signal sensor.
• Pulses of the signal sensor.
• Pulses of Revolutions.
Put the key in the ignition position and start the engine.
• Wait some seconds till the INITIAL screen appears on the DISPLAY.
• Press the button "TRIP" for 6 seconds and the Screen will show the digits to insert
the value of the development of the wheel, (the flickering digits are the selected ones)
following the sequence of pressing the button, we will choose the number and keeping
the button pressed for 3 seconds we will pass to the next digit, and so forth until set
the value.
Chassis
3