Reset The Receiver Collar; General Tips; Training Instructions - Petsafe PDT20-10644 Manual De Funcionamiento

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 47
Step

Reset the Receiver Collar

5
To reset the Receiver Collar to work with a new Remote Transmitter or to reprogram a
new Receiver Collar to work with your existing Remote Transmitter:
1. Turn the Receiver Collar off.
2. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Receiver Collar beeps 5 times.
3. Continue to hold the On/Off button until the Receiver Indicator Light has turned off.
4. Press and hold the Upper Button on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 60 cm - 90 cm
(2 ft - 3 ft) from each other before this occurs. Once the Receiver Indicator Light has
fl ashed fi ve (5) times, the Receiver Collar has been reset. If the Receiver Indicator
Light does not fl ash 5 times, start again and repeat the process.

Training Instructions

• Eliminate one misbehaviour or teach one obedience command at a time. If you move too fast with the training,
your pet may become confused.
• Be consistent. Give your pet an Audible Tone or Stimulation with each misbehaviour.
• Do not over-correct your pet. Use as few Stimulations as possible to train your pet.
• Unless you can supervise him, it is recommended that you restrict your pet from situations in which he has
a history of misbehaving. However, setting up a situation as a training session can dramatically improve your
chances of success.
• If your pet reacts to the training by hiding or acting fearful, redirect his attention to a simple and appropriate
behaviour such as the "Sit" command.
• Pets should be at least 6 months old before using the Remote Trainer.
• Only let responsible family members use the Remote Trainer. It is not a toy!
• The Lower Button can be used to deliver a slightly higher Stimulation Level on occasions when your pet ignores
his Recognition Level. Using this button is a quicker alternative than adjusting the Intensity Dial.
• The objective is to train your pet to respond to your spoken command and the Audible Tone from the receiver
in normal circumstances. After proper training, the use of Stimulation should only be necessary if your pet
repeats unwanted behaviour.
WARNING
Not for use with aggressive dogs. Do not use this product if your dog is aggressive, or
if your dog is prone to aggressive behaviour. Aggressive dogs can cause severe injury and even death
to their owner and others. If you are unsure whether this product is appropriate for your dog, please
consult your veterinarian or a certifi ed trainer.
12

General Tips

www.petsafe.net
Tabla de contenido
loading

Este manual también es adecuado para:

Pdt20-10645

Tabla de contenido