Assembly Instruction - cecotec FIT X-BIKE PRO Manual De Instrucciones

ENGLISH
• Be aware of your body signals. Incorrect or excessive exercise can deteriorate your health.
Stop exercising if you experience any of the following symptoms: pain, tightness in your
chest, irregular heartbeat, extreme shortness of breath, light-headedness, dizziness or
nausea. If you experience any of these conditions, you should consult your doctor before
continuing with your exercise program.
• This product is intended for domestic use only. It is not suitable for commercial or industrial
use. Do not use it outdoors.
• Only one person at a time should use the equipment.
• Keep hands and any loose clothing or objects away from all moving parts of the product.
• Always wear appropriate workout clothing when exercising. Do not wear loose or baggy
clothing, since it may get caught in the equipment. Wear athletic shoes to protect your feet
while exercising.
• Do not place any sharp objects around the equipment.
• This product is suitable for user's weight of up to 110 kg.
• Always use the equipment as indicated in this instruction manual. If you find any defective
component while assembling or checking the bike, or if you hear any unusual noise coming
from the equipment during use, stop using the bike. Do not use the equipment until the
problem has been rectified.
• The safety level of the bike can only be maintained through regular examination for
damage and/or wear and tear signals.
• Check that the bolts and nuts are securely fastened before using the equipment.
• No liability is accepted for any eventual damage or personal injuries derived from misuse
or non-compliance with this instruction manual.

3.ASSEMBLY INSTRUCTION

STEP 1: Attach the two stabilizers (4 and 23) to the main frame (21) using
four dome nuts (3), curved washers (2) and carriage bolts (1).
STEP 2:The pedals (5) & (22) are marked "L" and "R"- Left and Right.
Place them in their appropriate crank. The right crank is on the right side
of the bike. Note that the right pedal should be screwed clockwise,
while the left pedal must be screwed counterclockwise.
14 X-BIKE PRO
STEP 3: Align the seat (13) with the seat support (24). Adjust the angle of
the seat. Fix it tightly with nuts and flat washers (7, 8).
STEP 4: Fix the backrest (11) to the seat support (24) with two allen
screws (25), flat washers (8), and nuts (7).
STEP 5: Remove the preinstalled bolts, washers, and nuts from the rear
armrest (12). Fix the armrest to the backrest support with these parts.
Make sure the handlebar faces forward.
STEP 6: Fasten the front handlebar (14) to the main frame (21) with two
allen screws M8x35 (15) and curved washers (2).
STEP 7: Remove the screw (19) from the monitor support (20). Fix the
monitor support with the screw. Slide the LCD monitor (18) into the
monitor support and plug it.
ENGLISH
X-BIKE PRO 15