Honeywell Domonial CMI800 Manual Del Usario página 12

E
N
EKZ008500A
G
Alert codes
L
Transmission
I
S
Call sequence
Alarm code
H
End alarm code
Alert 1
Alert 2
Alert 3
Periodic line tests
Test 1 period
Test 1 start hour
Test 1 start minute
Test 2 period
Test 2 start hour
Test 2 start minute
Incoming calls
Accept calls
Number of rings
Driven outputs (types A25 and A27)
Driving mode
Delay before action
Duration of action
Idle state
If the driving mode is 1-4, the output may be associated with a keyfob. To do this :
note the actuator channel from the device information screen. The actuator channel appears as 2 digits XX on the second line under the
•
form CH AXX.
Select in the device information screen the keyfob that should drive the actuator.
•
Configure the receiver associated to that keyfob through code $ ', as indicated in the Keyfobs codes reference above.
•
0 = OFF
1 = Alarm/End
0 = Sequence 1 to 5 = Sequence 6
3 digits
3 digits
Transm.
!  #
!  &
!! 
"  %
0 to 44639 in minutes (24h = 1440 min)
" " $
0 to 23
" # '
0 to 59
"  '
0 to 44639 in minutes (24h = 1440 min)
" " &
0 to 23
" # 
0 to 59
0 = Never
#! &
1 = After N rings
# 
2 to 12
1 = driven by detector or user request
2 = timed, triggered by detector or user request
3 = timed, triggered by detector or user request, second trigger ignored
4 = toggled by detector or user request
5 = active while transmitting
6 = active while listening
" 
7 = siren after alarm, only if transmission is impossible
8 = siren after alarm, regardless of transmission
9 = set if Part zone is set
10 = set if Total zone is set
11 = set if Annex zone is set
13 = flashlight, timed or maintained until the system is disarmed.
14 = timed, triggered by detector or user request only after an alarm
" !
0 to 240 in seconds*5 (150 for 30s) - For modes 2, 3, 7, 8, 13 and 14
"! $
0 to 240 in seconds*5 (900 for 180s) - For modes 2, 3, 7, 8, 13 and 14
"" '
0 = OFF, 1 = ON
2 = Alarm
Call seq. Alarm code
!  ' ! $ #
!   ! $ &
!! # !!$ 
End alarm code
! % '
! %
!!% #
2 = Double call
12/64