Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SM 1619X05087 12-09:SM 1619X05087 12-09 1/4/10 9:18 AM Page 20
material is soft, drill only 2/3 the proper length.
If it is hard, drill the entire length.
Second, unclamp the pieces and drill the
second hole the same diameter as the screw
shank in the first or top piece of wood.
Third, if a flat head screw is used, countersink
the hole to make the screw flush with the
surface. Then, simply apply even pressure when
driving the screw. The screw shank clearance
hole in the first piece allows the screw head to
pull the pieces tightly together.
F STENING WITH
FIG. 4
SCREWS
1. Drill 2/3 diameter and
2/3 of screw length for
soft materials, full
length for hard
materials.
Apply a slight
even pressure
when driving
screws.
2. Drill same
diameter as
screw shank.
3. Countersink
same
diameter
as screw
head.
Screw
20
M INTEN NCE
Service
NO USER SERVICE BLE
W RNING
P RTS INSIDE. Preventive
maintenance performed by un au thorized
personnel may result in misplacing of
internal wires and components which could
cause serious hazard.
TOOL LUBRIC TION
Your Skil tool has been properly lubricated
and is ready for use.
D.C. MOTORS
The motor in your tool has been engineered for many
hours of dependable service. To maintain peak
efficiency of the motor, we recommend it be examined
every six months. Only a genuine Skil replacement
motor specially designed for your tool should be used.
Cleaning
To avoid accidents, always
W RNING
disconnect the tool and/or
charger from the power supply before
cleaning. The tool may be cleaned most
effectively with com pressed dry air.
wear safety goggles when cleaning tools with
compressed air.
21
lways
Tabla de contenido
