Final Assembly - Robern M Serie Instrucciones De Instalación

Final Assembly

Installing the Cold Storage Unit
Once the cabinet and side kits (if
used) are installed, and the electrical
connections made, the Cold Storage
unit can be installed into the cabinet:
1. Slide the unit into the cabinet.
2. Connect the Power Connector as
shown in Figure M.
3. Tighten the thumbscrew inside
the electrical box as shown in the Figure M
enlargement.
4. Re-install the four screws on
the electrical box cover as shown in Figure
M, making sure not to crimp or pinch wires
and connections.
5. Re-install the screw on the
bottom, outside of the cabinet
to secure the unit as shown in
Figure C on page 3.
Installing the Top Mirror Cap
The top mirror cap covers the electric box inside the
cabinet.
1. The mirror cap comes with two pieces of heavy-duty
Velcro installed on the back.
2. Align the two Velcro pieces on the cap with the Velcro
pieces on the surface of the electric box and foam
header inside the cabinet. Firmly push the cap onto
the box as shown in Figure N.
THUMBSCREW
COLD STORAGE UNIT
Installing the Shelves
1. Insert clear snap-in Shelf Clips into
2. Push one side of the shelf into the left or right clip (A).
3. Snap the shelf down into the opposite side (B). If the
Figure N
4. Install the Shelf Hole Plugs into the unused holes
5. Place the grey Screw Head Caps over any exposed
VELCRO
MIRROR CAP
9
ENGLISH
ELECTRICAL BOX
COVER SCREWS
POWER
CONNECTOR
CABINET
Note that the set of two shorter glass shelves are
installed inside the cold storage unit and the longer
shelves are installed in the cabinet side.
the holes on the sides of the cabinet.
See Figure O.
shelf is too tight, repeat the process starting from the
opposite side.
inside the cabinet by pressing them into the holes.
screw heads.
A
B
209-1095 M Series Cabinet with Cold Storage 09/15/09
Figure M
NOTE: LEFT DOOR
MODEL SHOWN
Figure O