Adjustments & Maintenance; Cleaning And Care - Robern M Serie Instrucciones De Instalación

Adjustments & Maintenance
Cabinet Doors
The cabinet doors have a three-way adjustment feature.
Height, level, and fit-to-frame can all be adjusted using a
#2 Phillips Head screwdriver.
■
HEIGHT: If the door is too high or low, adjust the door
down or up with screw #2 as shown in Figure P. This
screw is located inside the hinge and requires the door
to be opened approximately 90° to access the screw.
■
LEVEL: If the door is out of level or too close to one
side, adjust the door to the left or right using screw #1 as
shown in Figure P.
■
FIT-TO-FRAME: If the door opens stiffly, squeaks, or
rubs against the gasket, adjust the door outwards with
screw #3 as shown in Figure P.
HINGE
1 2
DOOR
ADJUST DOOR PITCH
SIDE-TO-SIDE
USING SCREW #1
Door "Swing"
Check the swing of the cabinet door. The door hinges
come with a 110° black
swing into a light kit. If no light kit is installed, the stop
is not necessary and the door can be allowed to swing
170°. If hinge stops are required, snap the
over the elbow of the hinge into the holes located on the
hinge.
209-1095 M Series Cabinet with Cold Storage 9/15/09
Figure P
MOUNT OR
UNMOUNT
DOOR,
OR ADJUST
FORWARD OR
BACKWARD
USING SCREW #3
3
ADJUST DOOR
UP/DOWN
USING SCREW #2
plastic hinge stop so they will not
hinge clip

Cleaning and Care

The cabinet door and interior are constructed of mirrored
glass and aluminum. Use only a damp cloth to clean.
Ammonia or vinegar-based cleaners can damage
mirrors. A 50/50 solution of water and isopropyl alcohol is
recommended for cleaning the mirrors. A mild detergent
may be used on the surfaces.
When cleaning, spray the cloth, not the cabinet, mirror,
or surround surfaces.
Do not use abrasive cleansers on any part of the cabinet.
NOTE:
Do not store items in the cabinet area directly
behind the hinge as damage may occur to
cabinet or items.
The Drip Tray
The Drip Tray collects condensation and is attached
to the bottom, outside of the cabinet. The drip tray
automatically evaporates the condensation and therefore
does not need to be emptied or monitored. If you notice
any liquid dripping over the tray, see the Troubleshooting
Guide (Table 1 on page 2) of the Operating Instructions
for the M Series Cabinet with Cold Storage.
0
ENGLISH