Robern M Serie Instrucciones De Instalación página 7

How to Gang Cabinets Together
Each cabinet and Side Kit contains special connectors to
allow many different combinations of cabinets, both surface-
mounted using the Side Kit and recessed into the wall. An
example using these connector combinations is shown in
Figure I and Figure J.
NOTES:
Assemble the boxes on a convenient flat surface, not
on or in the wall.
If you purchased lights, check the instructions provid-
ed with the light kits. Do not attach doors, or side kits
until the boxes are secured to the wall.
Note the location of holes in the cabinets which are
used to secure connectors and side kits (see Figure D
on page 4).
1. With the doors off, combine the cabinet boxes with the
proper connectors to assemble the units per your layout.
Use the #10 X ½" (12.7 mm) Thread Cut screws to attach
the boxes.
On non-hinge side use the four #10 X ½"
NOTE:
(12.7 mm) Flat Head screws. On the hinge side use
the two #10 X ½" (12.7 mm) Pan Head screws and
two #10 X ½" (12.7 mm) Flat Head screws.
2. Depending on how you are going to install your cabinets
go to "How to Surface Mount Cabinets" on page 5 or
"How to Semi-Recess Mount Cabinets" on page 6.
NOTES FOR SURFACE MOUNTING
CONNECTED CABINETS
■
For combinations of cabinets more than 45" (1143 mm)
wide, you must use more than one mounting bar.
CAUTION:
A complete 3-door unit is 120 - 150 pounds (54.4
- 68 kg) when empty. It is strongly recommended
that a support similar to that used for a wall-
mounted sink be framed into the wall during
construction as shown in Figure E on page 5.
■
A three-cabinet installation on a hollow wall
should have 9 anchors in the Mounting Bar
(follow the Poly-set Anchor instructions on page 5).
CABINET
CONNECTOR
THREE CABINET COMBINATION FOR RECESS INSTALLATION.
7
ENGLISH
CONNECTOR BLOCKS
Use Side Kit for surface mount.
Refer to Figure G on page 6.
CABINET
CONNECTOR
209-1095 M Series Cabinet with Cold Storage 09/15/09
Figure I
#10 X 1/2" (12.7 mm)
SCREWS
Figure J
CABINET