Trouble Shooting - koban KDP1 360FP Manual De Instrucciones

Trouble shooting

When KPD1 works abnormaly, please check assumptive problems
and suggested solutions in following table that will hopefully to solve
your problems.
Problem Possible cause
Lighting 1.Power does not turn on.
device does 2.Wired incorrectly.
not turn on 3.The ambient light level is
too high.
4.Malfunctioned load.
Lighting 1. Incorrect time setting
device does 2.Detector is nuisance
not turn off triggered.
3. Wired incorrectly.
www.grupotemper.com
FIG.24
Suggested solution
1.Switch on the power
2.Refer to wiring diagrams
(FIG.5-FIG.7) and check if the
load is malfunctioned.
3.Set Lux value to be above
the ambient light level then
trigger the detector and
check if the load is switched
on or not.
4.Replace the disabled
load with a new one.
1.Set auto off time to a
shorter time and check if the
load is switched off or not
according to the pre-set time
2.Keep away from detection
coverage to avoid activating
detector while doing the test.
3.Make sure load and wires
are connected correctly.
KDP1 360 FP
Presence detector
Instructions manual | 39