Clean-Up After Installation - Kohler Sterling 72141110 Manual Del Usuario

6. Finish the Installation
IMPORTANT! Risk of property damage. Make sure a watertight seal has formed around the receptor
drain and overflow.
NOTE: Follow the manufacturer's instructions for the installation of the drain, valve trim, and
showerhead.
For All Installations
Connect the drain to the trap according to the manufacturer's instructions.
Seal the holes cut in the plumbing end wall.
Install and seal all escutcheons, cover plates, or flanges.
Install the valve handles or shower control handle.
Remove the protective covering from the receptor. Clean any debris from the receptor.
Check the drain connection for leakage. Repair if necessary.
Install the showerhead with pipe sealant.
Install Miscellaneous Accessories
IMPORTANT! Risk of property damage. Do not make additional holes in the receptor without adding
adequate clear silicone sealant. Additional holes made to install any accessories may cause leakage.
Improper installation of accessories may void the warranty.
Verify that any holes in the finished wall are properly sealed with clear silicone sealant.
Allow the silicone sealant to set according to the sealant manufacturer's instructions.
When the sealant has set, check for leaks.

7. Clean-up After Installation

IMPORTANT! Risk of product damage. Do not use abrasive or acid-based cleaners on this product.
Wipe your shower unit with a soft cloth after each use to prevent build-up of soap and scum.
If the surface gets excessively dirty, refer to the Homeowners Guide for recommended cleaning
products. Avoid cleaning products that contain acetone, ethyl alcohol, amyl or ethyl acetate, sodium
hypochlorite, toluene, or phenol. These products can damage the finish.
IMPORTANT! Risk of product damage. Products that generate extreme heat (such as cigarettes or
portable heaters) can damage the surface of this product.
Sterling 9 1049440-2-A