Maintenance And Care; Cleaning The Blade System; Replacing The Scarifier Or Aeration Roller (12, 13, 14); Transport - AL-KO COMBI-CARE 36 E Comfort Traducción Del Manual Original De Instrucciones

Maintenance and care

■
In the following cases, visit the customer ser-
vice workshop:
■
Motor no longer starts.
■
Appliance has moved onto an obstruc-
tion.
■
Appliance vibrates and does not run
smoothly.
■
The blades of the scarifier roller or steel
spring prongs of the aeration roller are
bent.
7 MAINTENANCE AND CARE
CAUTION!
Danger of lacerations
There is danger of lacerations when
reaching into the blade system while it is
running on or the stopped blade system.
■
Stop the appliance and wait until the
blade system has stopped.
■
Disconnect the mains plug to power
down the appliance.
■
Wear protective gloves.
7.1

Cleaning the blade system

IMPORTANT!
Danger from water
Water in the appliance causes short-cir-
cuits and destroys electrical components.
■ Do not spray the appliance with wa-
ter.
■
Only use a broom or a brush for
cleaning.
1. Stop the appliance and wait until the blade
system has stopped.
2. Disconnect the mains plug.
3. Remove the grass collector (see chapter 6.6
"Attaching and removing the grass col-
lector (10)", page 20).
4. Tip the appliance onto the side and clean the
blade system with a broom or brush.
7.2 Replacing the scarifier or aeration
roller (12, 13, 14)
The scarifier roller is intended for coarse scarify-
ing work and the aeration roller for fine scarifying
work (see chapter 2.3 "Scope of supply",
page 16).
441970_a
Removing the roller
1. Stop the appliance and wait until the blade
system has stopped.
2. Disconnect the mains plug.
3. Turn the underside of the appliance upwards.
4. Unscrew and lift out the socket head screws
(12/1) (pos. a).
5. Lift the roller (13/1) at one side on the de-
tached end (pos. b).
6. Pull the bearing shell (13/2) off the roller
(13/1) (pos c).
7. Pull the roller (14/1) off the roller drive (14/2)
(pos. d).
Installing the roller
Proceed in reverse order.

8 TRANSPORT

IMPORTANT!
Danger of damage to the appliance
The blade system will be damaged if the
appliance is moved over a solid surface
with the blade system lowered.
■
To raise the blade system, turn the
adjuster wheel for the working depth
to HIGH (level 1).
1. Stop the motor and wait until the blade sys-
tem has stopped.
2. Turn the adjuster wheel for the working depth
to HIGH (level 1).
3. Remove the mains plug from the power
socket, fold up the mains cable.
Transporting the appliance between two
working areas
■
Move the appliance to the working area with
the blade system raised.
■
To carry the appliance: Lift the appliance by
the carrying handle.
Transporting the appliance in a vehicle
■
Fold in the handlebar.
■
Secure the appliance in the vehicle against
falling over and sliding.
■
Secure the appliance against impacts from
loose objects.
■
Do not place objects on the appliance.
21