Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4.0 TRAINING AND SYSTEM INSPECTION
TRAINING
It is the responsibility of the user and the purchaser of this equipment to assure they
are familiar with these instructions and are trained in the proper use, installation,
operation, maintenance and limitations of this product. Training should be conducted
periodically and without exposing the trainee to a fall hazard.
Training is an integral part of our Total Solution in fall protection, since no fall
protection equipment – regardless of how effective – can save an employee who
is not trained in its use. To meet this crucial requirement, Miller Training provides
the knowledge and skills necessary to achieve a safe, more productive work envi-
ronment. For more information on Miller Training, contact a representative today:
800.873.5242
INSPECTION
Before each use, visually inspect for the following:
• Inspect for physical damages, wear and corrosion.
• Check tensioner for damage, crack, wear, corrosion or malfunctioning components.
• Inspect lifeline and anchorage line for cuts, frays, burns and broken fibers.
• For any missing, damaged or replacement parts call: 800.873.5242
• If Inspection reveals a defect in condition or has seen a fall, remove the units
from service.
TYPES OF MATERIAL DAMAGE
HEAT
In excessive heat,
polyester becomes
brittle and has a
shriveled brownish
appearance. Fibers
will break when
flexed. Should not be
used above 180°F.
5.0 SET-UP AND INSTALLATION
Before installation of this equipment, carefully inspect to assure that it is in useable
condition. Check for missing or damaged parts. If any parts are missing or damaged,
contact Miller Fall Protection before proceeding.
Anchorage connectors must be rated for 5,000 lbs (22.2KN) and chosen to locate
lifeline at or above the height of the D-ring on harness. See section 3.0 for diagram
and description reference. For proper set-up prior to use, follow steps 1-5.
USER INSTRUCTI ONS - EN GLI SH
CHEMICAL
Change in color
usually appearing as
a brownish smear or
smudge. Transverse
cracks when rope/
webbing is bent over
a mandrel. Loss of
elasticity in rope/
webbing.
8
MOLTEN
METAL OR
FLAME
Rope/webbing strands
fuse together. Hard
shiny spots. Hard and
brittle feel.
PAINTS AND
SOLVENTS
Paint which penetrates
and dries restricts
movement of fibers.
Drying agents and
solvents in some
paints will appear as
chemical damage.
Capítulos
Tabla de contenido
