Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Using the generator
© MOSA
REV.0-06/04
GROUND FAULT INTERRUPTOR SWITCH
The high-sensitivity ground fault interruptor
switch [G.F.I.] (30mA) (D), guarantees
protection against indirect contacts due to faulty
ground currents .
When the G.F.I. switch picks up a faulty ground
current that is higher than 30mA, it intervenes
by immediately cutting off tension to the AC
sockets.
In case of intervention by this
protection feature, reset the G.F.I.
switch, bringing the lever to the ON
position.
In case of another intervention, verify that no
faulty tools are connected, or replace the G.F.I.
switch with another of matching specifications
and/or contact the Service Department.
☞
Notes: verify the operation of the G.F.I.
switch at least once a month by pressing the
TEST button.
The generator must be running and the
differential lever in the ON position.
GENERATION IN C.C. (Continuous Current)
Maximum power in c.c.:
P = 120W - V= 12V AC
I = 10A
Generation in c.c. is mainly used to recharge
lead batteries.
- Verify that the battery to be charged is not a
dry battery, and that it is 12V c.c.
- Position the generator and battery on a flat
surface and distant from one another.
WARNING
It is dangerous to handle a lead battery;
follow the procedures outlined on page M
25.
- Connect the battery recharge cables one at a
time, avoiding accidental contacts between
them.
☞
Note: use cables with a minimum section of
2
6 mm
.
- Start the motor.
- Once recharging is complete, proceed in
opposite sequence, switching off the motor
and disconnecting the cables, etc.
THERMOPROTECTION
The 12V c.c. output is protected against
overloads by the thermoprotection device (59).
When current is exceeded, the protection
feature intervenes to cut off tension to the c.c.
terminals (Q4).
☞
Notes:
the
thermoprotection feature is not instantaneous,
but reacts according to an overcurrent/time
characteristic, whereby the greater the
overcurrent the quicker the intervention.
In case of intervention by the protection feature,
verify that:
- the c.c. terminal /battery connections respect
the polarities;
- the battery is not faulty or has a short-circuited
element;
- the battery level is not too low, with the
consequent recharge current being too high.
Eliminate the cause and
wait a few minutes to allow
the thermoprotection to
cool down.
Reset the protection feature by pressing the
central pole. If the protection should intervene
once more, replace it with another one with
matching intervention current specifications
and/or contact the Service Department.
M
GE 4000 LDS/GS
37.
GE 4500 HSX
intervention
of
PUSH TO
RESET
1
the
Tabla de contenido
