Deactivation/Activation Of The Audible Temperature 1 Alarm; Programming Of Temperature 2 For Slot 2; Choice Of Heat /Cool; Adjusting The Temperature 2 - Hobby Biothermpro Instrucciones De Uso

5.2.3 Deactivation/Activation of the audible temperature 1 alarm

When "OFF" is flashing, use the ▲ and ▼ buttons to activate the alarm with "ON" or to deactivate it by selecting
"OFF". Press
. when "TEMP 2" is flashing.

5.3 Programming of temperature 2 for slot 2

5.3.1 Choice of HEAT /COOL

To set the temperature 2 regulation, press
until TIME flashes, then press
Flashing " ".
Confirm with to select HEAT (
COOL ( ) (control of connected Cooling devices).

5.3.2 Adjusting the temperature 2

When "P01" is flashing, press
(P01 to P08 can be selected using ▲ and ▼)
When "CHA" is flashing, the ▲ and ▼ buttons can be used to select 'CHA' (change) or 'dEL' (delete).
If "CHA" is selected, press
Use the ▲ and ▼ buttons to set the hours between 0 and 23.
button, the minutes digits "00" will flash.
Press the
Use the ▲ and ▼ buttons to set the minutes between 0 and 59.
button, the desired temperature value will flash - "25.0".
Press the
Use the ▲ and ▼ buttons to set the desired temperature value between 0 and 60.
If "P02" flashes, you can program further time periods in the same manner.
If you do not wish to set further time periods, press and hold the
Note: It is not possible to enter turn-off times. The start time of, for example, P02 is the end time of P01. If only P01
10
. (To set the timer control (alternative to temperature control), press ▼
and continue with item 5.4 of these instructions)
) operating mode (control of connected Heaters) or use ▲ and ▼ to select
to program position 1.
to confirm, the hours "00" will flash".
button for a few seconds.