Programming Of Temperature 1 For Slot 1; Adjusting The Temperature Value 1 - Hobby Biothermpro Instrucciones De Uso

5.2 Programming of temperature 1 for slot 1

5.2.1 Adjusting the temperature value 1

When "P01" is flashing, press
(P01 to P08 can be selected using ▲ and ▼)
When "CHA" is flashing, the ▲ and ▼ buttons can be used to select 'CHA' (change) or 'dEL' (delete).
If "CHA" is selected, press
Use the ▲ and ▼ buttons to set the hours between 0 and 23.
button, the minutes digits "00" will flash.
Press the
Use the ▲ and ▼ buttons to set the minutes between 0 and 59.
button, the desired temperature value will flash - "25.0".
Press the
Use the ▲ and ▼ buttons to set the desired temperature value between 0 and 60.
If "P02" flashes, you can program further time periods in the same manner.
If you do not wish to set further time periods, press and hold the
Note: It is not possible to enter turn-off times. The start time of, for example, P02 is the end time of P01. If only P01
is set, the programmed levels are maintained over 24 hour. It is advisable to program at least two time periods to
differentiate day values and night values.
Attention: If two or more times for the start of temperature control are identical, the error E5 appears on the display.
5.2.2 Alarm setting temperature 1
When "00" flashes, use the ▲ and ▼ buttons to set the +/- alarm between 1 and 10° C. Press
"00" means that no alarm is set.
to program position 1.
to confirm, the hours "00" will flash".
button for a few seconds.
.
9