Setting The Current Time; Installing The Remote Controller Holder - Mitsubishi Electric PAR-FL31MA Libro De Instrucciones

4-3. Setting the Current Time

1. When using for the first time, following replacement of batteries or pressing the reset button:
ON/OFF
MODE
CLOCK
FAN
VANE STOP START
HR. MIN.
2. When changing the current time:
ON/OFF
MODE
CLOCK
FAN
VANE STOP START
HR. MIN.

4-4. Installing the Remote Controller Holder

™ To place the wireless remote controller on a wall, the remote controller holder must be installed as
shown below.
Remote
controlle
holder
CHECK TEST RUN
NOT AVAILABLE
All the LCD displays will light up for three seconds, then "AM 0:00
" starts to blink. After "AM 0:00
following procedure.
MODE
1. Press the HR. and MIN. buttons to adjust the time to current
time.
2. Press the CLOCK button. The current time will blink and the
" " display will disappear.
All the LCD displays will disappear in 10 seconds.
NOT AVAILABLE
MODE
Wood screws
(4.1×16)
3 seconds
later
˚C
AM
PM
AM
PM
ON/OFF
1. Press POWER ON/OFF button if
the LCD displays are not on.
2. Press the CLOCK button. Check
that "
˚C 3. Press the HR. and MIN. buttons to
adjust the time to current time.
4. Press the CLOCK button to com-
PM
plete the setting.
∗ Even if the CLOCK button is not
pressed, "
ON/OFF
minute.
How to Place the Controller in the Holder
2
1 Slip the remote controller into the holder.
2 From that position, push the controller to-
1 wards the wall.
How to Remove the Controller from the
Holder
• Pull the upper part of the remote control-
ler towards you.
AM
NOT AVAILABLE
ON/OFF
" starts blinking, carry out the
MODE
" is displayed.
" will disappear in one
9