Bluewater PRO Serie El Manual Del Propietario página 14

Symptom
The flow rate from the
clean water faucet is
low.
The water purifier starts
and stops again (short
starts).
There is a bad smell
from the water purifier.
Owner's manual
Cause
The salinity of the feed water
has increased.
The water quality meter does
not work correctly.
The tap has been on for more
than 15 minutes. The water
purifier has stopped. (Pro
400B)
The leak protection system is
activated.
The first time cleaning
procedure is ongoing.
The first time cleaning
procedure has been
interrupted.
The first time cleaning
procedure has been
interrupted.
The clean water tube is
tensioned or jammed.
The water purifier needs to be
descaled.
The water pressure between
the water purifier and the
faucet/valve/tank is below the
starting pressure level.
Microbial growth in the water
because the water purifier has
not been used for a week or
longer.
Solution
Contact your Bluewater dealer.
Disconnect the water purifier from
power. Connect it again to start the
automatic flush. Do not use the water
purifier for 30 minutes.
Turn off the tap and wait at least
30 minutes.
Push the button to start the water
purifier. Release the button when the
stop light goes out.
Disconnect the water purifier from
power, and clean the base plate.
The water purifier is working correctly.
Make sure that the feed water pressure
is sufficient. Push the button to start the
water purifier.
Open the faucet on the clean water
tube (and on the rinse water tube for CV
models).
Make sure that the clean water tube can
move freely.
See Complete User manual.
Examine the connections.
Make sure that the ends of the water
tubes are circular and have no burrs.
Make sure that the faucets and the valves
are water tight when they are closed.
See Complete User manual.
14