Maintenance And Storage - Pulsar CORE FXQ35 Manual Del Usario

Compatibility chart of inserts for day devices
42 45.5
46
46.5
46.7-47.6
47.7-48.6
48.7-49.6
49.7-50.6
50 51.6
53.4
54.7-55.6
55.7-56.6
56.7-57.6
57.7-58.6
58.7-59.6
56 59.7-60.6
60.7-61.6
61.7-62.6
62.7-63.6
63.7-64.6
64.7-65.6
Remove the cover (14) from the cover ring adapter by turning it counter-
џ
clockwise.
Install the insert (12) fully into the adapter (13) (Fig.3)
џ
Important! The insert must be installed with the tapered part facing
џ
downwards.
Install fully the adapter with the insert onto the objective lens (11) of the day
џ
device.
Snap the lever (19) from the original OPEN position to the CLOSE position
џ
(Fig.4). Check that the adapter fits the objective lens snugly.
11
12
13
Fig. 5
12
45.5
46
46.5
47
48
49
50
51.6
53.4
55
56
57
58
59
60
61
62
63
64
65
17
16
14
18
19
If you see there is a gap please:
џ Loosen the locking screw (18) with the hex-nut wrench (S=2mm).
џ Tighten the screw (17) with hex-nut wrench (S=4mm) with a clamping force
necessary to ensure that the adapter fits tightly the objective lens.
Tighten the locking screw (17).
џ
It is recommended that you degrease the objective lens body of your day
device and the inner side of the insert before installing the cover adapter.
To install the thermal imager on a day device, match the adapter's pins with
џ
the grooves on the thermal imager and turn clockwise, the lock (15) must
snap.
To reattach the monocular back to the thermal unit, remove the day device,
џ
insert the monocular's pins into the grooves of the thermal unit and rotate
clockwise, until the lock snaps.
12

MAINTENANCE AND STORAGE

The unit features degree of protection IPX7/IPX5 (IPX7 - fully waterproof,
џ
submersible at 1 metre for 30 minutes; IPX5 – protection against intrusion of
water jets).
Clean the device's optical surfaces only if necessary, and use caution.
џ
Firstly, remove (by blowing with a blower brush or canned air) any dust or
sand particles. Then proceed to clean by using camera/lens cleaning
equipment approved for use with multicoated lenses. Do not pour the
solution directly onto the lens!
Always store the unit in its carrying case in a dry, well-ventilated space. For
џ
prolonged storage, remove the batteries.
Batteries should not be exposed to excessive heat, such as sunshine, fire or
џ
similar sources.
13
TROUBLESHOOTING
Listed below are some potential problems that may occur when using the
device. Carry out the recommended checks and troubleshooting steps in the
order listed. Please note that the table does not list all of the possible
problems. If the problem experienced with the scope is not listed, or if the
suggested action meant to correct it does not resolve the problem, please
contact the manufacturer.
13