Maintenance And Storage; Troubleshooting - Pulsar TRAIL Manual De Instrucciones

23
TECHNICAL INSPECTION
Check:
External view (there should be no cracks on the housing).
The state of the objective and eyepiece lenses (there should be no
cracks, spot, dust, deposits etc.).
The state of the Battery Pack (should be charged) and electric
terminals (there should be no oxidation).
Correct functioning of the controls.
24

MAINTENANCE AND STORAGE

Maintenance should be carried out no less frequently than twice a year,
and should consist of the following measures:
Wipe external plastic and metal surfaces clean of dust and dirt with a
soft cloth moistened with a synthetic cleaning agent.
Clean the electric terminals of the Battery Pack and sight's battery slot
using a grease-free organic solvent.
Check the objective and eyepiece lenses. If required, remove dust
and sand (preferably by a noncontact method). Clean the external
surfaces of the lenses with products expressly designed for this
purpose.
Always store the sight in its carrying case in a dry, well-ventilated
space. For prolonged storage, remove the batteries.
25

TROUBLESHOOTING

The table presented below lists some potential problems that may occur
when using the sight. If a problem encountered with the sight is not listed,
or if the recommended action does not resolve the problem, the unit
should be returned for repair.
Problem Check
The thermal sight Battery Pack is discharged.
will not turn on.
The sight does not USB cable is damaged.
operate on external
External power supply is
power supply.
discharged.
The image is blurry, Calibration is required.
with vertical stripes
and uneven
background.
6 31
Corrective action
Charge the battery.
Replace USB cable.
Charge the external power
supply (if necessary).
Carry out calibration according
to Section "SENSOR
CALIBRATION".
Problem Check
The image is too Brightness or contrast level
is too low.
dark.
The reticle is blurred The dioptre cannot be
and cannot be adjusted to your eyesight.
focused with the
dioptre knob.
With a crisp image of Dust and condensate are
the reticle, the image covering the outside optical
of the observed surfaces after the sight was
target that is at least brought in from the cold into
30 m away is blurred. a warm environment, for
example.
The objective lens is not
focused.
The aiming point The sight is not mounted
shifts after firing securely or the mount was
rounds. not fixed with thread sealant.
The sight will not Wrong settings.
focus.
The sight cannot be Remote control is not
powered on activated.
with wireless remote Low battery.
control.
Corrective action
Adjust brightness/contrast with
the UP/DOWN buttons.
If you wear prescription glasses
with a range of +/- 4, keep
glasses on when looking
through the eyepiece
Clean the lens surfaces with a
blower and soft lens cloth.
Let the sight dry by leaving it in
a warm environment for 4
hours.
Adjust the image by rotating the
lens.
Check that the sight has been
securely mounted, make sure
that the same type and calibre
bullets are being used as when
the scope was initially zeroed; if
your sight was zeroed during
the summer, and is now being
used in the winter (or the other
way round), a small
displacement of the aiming
point is possible.
Adjust the sight according to the
instructions given in the Section
9 "OPERATION" and check the
surfaces of the eyepiece and
objective lenses and clean
them if necessary from dust,
condensation, frost, etc; to
prevent fogging in cold weather,
apply a special anti-fog
solution.
Activate the remote control
according to instructions.
Install a new CR2032 battery.
32