Abicor Binzel ABIPLAS WELD 100 Instructivo De Servicio página 33

®
ABIPLAS WELD
BAL.0092 • 2020-12-17
4 Introduce centring ceramics into the torch body. In doing so, the tungsten
electrode must be guided through the central bore of the ceramics.
5 The alignment gauge is used to determine the level of adjustment of the
tungsten electrode length. To this end, screw the alignment gauge into the
torch body. The tungsten electrode tip must rest on the groove's stop
shoulder. Tighten the tungsten electrode in this position with the back cap.
NOTICE
• The poor current and heat transfer of loosely fitted plasma nozzles may
result in irreparable damage to the torch.
6 Screw the plasma nozzle into the threaded bore and tighten with the
alignment gauge.
7 Place the insulating ring over the outside thread of the torch body until it
makes contact with the torch body's plastic protective cover.
8 Screw the gas diffuser onto the outside thread of the torch body as far as it
will go.
9 Screw the ceramic gas nozzle 'hand tight' onto the outside thread of the
torch body until it sits gap-free in the insulating ring's radial groove.
6 Putting into operation
EN - 13