Entering Your Security Code - STACK-ON PFWS-080-B-D-E Manual Del Propietário

ENTERING YOUR SECURITY CODE

STEP 1
To enter your own security code you will need to follow the steps listed below:
After installing the batteries, locate the reset button on the edge of the hinge side of the door.
Press the red reset button and then release it, you will hear a beep.
NOTE: The red reset button located on the
inside of the door, is covered with a removable
red cap. When you use the red reset button
while setting your own combination, remove the
cap to access the button.
Replace the cap securely over the red reset
button after setting your combination. Failure to
do so will compromise the safety and security of
the safe.
DO NOT SHUT THE DOOR UNTIL YOU HAVE CONFIRMED YOUR NEW SECURITY CODE HAS BEEN
ENTERED CORRECTLY.
You will have 3 seconds to press the
key otherwise you will have to start over from
step one. There will be 2 beeps (if the sound is
turned on) and the green light will flash twice if
your code has been entered successfully.
Before you close the door, enter your new
security code and press the
sure the lock releases the handle so you can turn
it and retract the live action locking bolts.
PERSONAL FIREPROOF AND WATERPROOF SAFES
®
key to make
PAGE 5 of 26
OWNER'S MANUAL
STEP 2
With the door open, enter your own personal
security code, which can be 3-8 digits long,
and confirm your new code by pressing the
key on the electronic touch pad.
STEP 2 CONTINUE TO PAGE 6
PFWS_2010