Safety Instructions - Anton Paar DMA 4100 Manual De Instrucciones

2 Safety Instructions

•
•
•
•
•
•
•
•
•
•
•
•
•
•
XDLIB28
This instruction manual does not claim to address all of the safety issues
associated with the use of the DMA 4100/4500/5000 and samples. It is the
responsibility of the user to establish health and safety practices and
determine the applicability of regulatory limitations prior to use.
Before using the DMA 4100/4500/5000, read this instruction manual
completely.
Anton Paar GmbH only warrants the proper functioning of the DMA 4100/
4500/5000 if no unauthorized adjustments have been made to mechanical
parts, electronic parts and software, and the following points are adhered to.
Follow all hints, warnings and instructions in the instruction manual to ensure
the correct and safe functioning of the DMA 4100/4500/5000.
Do not use the DMA 4100/4500/5000 for any purpose other than described
in the instruction manual. Anton Paar GmbH is not liable for damages
caused by incorrect use of the DMA 4100/4500/5000.
Do not use any accessories other than those supplied or approved by Anton
Paar GmbH.
The installation procedure should only be carried out by authorized
personnel who are familiar with the installation instructions.
Do not operate the DMA 4100/4500/5000 if a malfunction is suspected, or
damages, injuries or loss of life cannot be excluded under all circumstances.
The DMA 4100/4500/5000 is not an explosion-proof instrument and
therefore must not be operated in areas where there is a risk of explosion.
Service and/or maintenance procedures which involve removing outside
covers and working with the power switched on may only be performed by
authorized service personnel.
Ensure that all operators are fully trained to use the DMA 4100/4500/5000
correctly and safely.
Due to the nature of the measurement, the measuring results not only
depend on the correct use and functioning of the DMA 4100/4500/5000, but
may also be influenced by other factors. We therefore recommend that the
analysis results are plausibility tested before consequential actions are
taken.
Repair and service procedures may only be carried out by authorized
personnel or by Anton Paar GmbH.
Dispose of the DMA 4100/4500/5000 according to the country-specific legal
requirements.
2 Safety Instructions
7
E N