Using Magicspeed - Waeco MS-BE6 Instrucciones De Montaje Y Uso

MagicSpeed Accessory
10

Using MagicSpeed

MagicSpeed is controlled using the button on the control lever.
Enabling and disabling MagicSpeed
➤ Press the ON/OFF button once to switch on the speed regulator.
✓ The LED on the control lever lights up.
➤ When the speed regulator is switched on, press the ON/OFF button once
to switch it off.
✓ The LED on the control lever goes out.
✓ The last saved speed will be discarded.
Saving your desired speed
Use the SET/ACC button to save the speed you want on the speed regulator.
Caution
a
The engine can be damaged if the speed is too high. Save the
desired speed whilst underway when you are travelling at that
speed.
➤ Press the SET button and let go again immediately to set the speed you
are currently driving.
This set speed is maintained until:
– You press the brake or clutch pedal
– You switch off the device with the ON/OFF button
– The car slows down to below the lower activation speed
– The speed drops on a slope by more than 25%.
➤ Press and hold down the SET button to accelerate the car.
When you let go of the SET button the speed regulator records the
current speed and saves it.
Using MagicSpeed
35