General Warnings; Transport And Handling; Identification Of The Product; Product Description - SAER Elettropompe TM Serie Manual De Empleo Y Mantenimiento

®
ELETTROPOMPE
2.2

General warnings

Tampering with the product is prohibited.
The user is responsible for dangers or accidents in relation to other persons and their property.
Use the pump/electropump only for the purposes described in the paragraph "Anticipated use." Any other
use can be a cause of accidents.
Each transport, installation, connection, setting at work, control and eventual maintenance or stop operation
shall be executed by trained and qualified staff. Furthermore, possible local regulations or directions not
mentioned in this manual must be taken into consideration as well.
Before executing any operation, the feeder cables shall be disconnected from the terminals of the motor.
Never touch the electric pump while it is working.
Do not touch any parts of the pump when it is operating: maximum temperature for the supports 95°C, the
temperature of the pump body depends on the temperature of the liquid (max 120°C). It's the installer's
responsibility to use the suitable protections to avoid any risk of contact with hot surfaces, but ensuring the
necessary air exchange for cooling the pump and the motor.
With dangerous liquids or liquids having a temperature >60°C, the pump must be provided with devices for
the collection and the safe disposal of the drained liquid or of the liquid coming from possible leaks.
In case of motor with internal combustion, forecast a device of collection and safe disposal of gas.
3. Transport, handling and intermediate storage
3.1

Transport and handling

Make sure that the lifting means adopted have a capacity adequate to the load to be lifting and that they
are in good condition.
Do not pause or pass under the load during lifting or transport.
The pump/group must only be lifted using an adequate lifting device (crane, lift truck, etc.). The sling must be made
as shown in fig. 2a and 2b. Adjust the length of the cables or belts so that the load is maintained horizontal.
3.2 Storing and preservation
During periods of storage, the material must be protected from humidity, dirt, vandalism or access by
unauthorised personnel.
If the pump/electropump remains inactive at low temperatures (the water inside the pump could freeze and
cause serious damage) or, at any rate, for a period exceeding three months, it is a good idea to empty the
pump and protect it by applying suitable products to its surfaces. To empty the liquid, see the chapter
"Decommissioning and disposal."
4. Technical specifications and use
4.1

Identification of the product

The identification data and technical characteristics of the pump/electropump are shown on the plate attesting to its
conformity to CE standards (fig.1).
4.2

Product description

Centrifugal multistage horizontal pumps driven by elastic or hydro-dynamic coupling, anti-clock wise rotation looked
from drive side. The pumps in the TM series can be connected to electric, Diesel, hydraulic engines or turbines whose
revs are within a range of 1450 and 3500.
TMZ-2P: Electric pump with 2 poles motor 2950 rpm
TMZ-4P: Electric pump with 4 poles motor 1450 rpm
12