Safety Concerns & Installation Warnings - Blaupunkt ProComponent PCA 250 Manual De Uso

S C
AFETY ONCERNS
We always recommend you have your Blaupunkt amplifiers professionally installed but the
installation process is often so easy that the average consumer can achieve success with little
trouble. Regardless of the person installing, you should be sure to review the following points
before proceeding with the installation:
READ THE MANUAL!
lifting a screwdriver.
WEAR SAFETY GLASSES AT ALL TIMES
PROTECT THE VEHICLE
starting any kind of installation work. This prevents a poss ble high current electrical
short (potential fires).
HEAT
- Keep all audio components away from nearby hot vehicle components that heat up over time such as hoses,
high current wires, and braking system components.
GIVE YOURSELF LOTS OF TIME
DO NOT LISTEN AT HIGH SOUND LEVELS FOR A PROLONGED TIME
efficiency speakers from ANY manufacturer, have the potential to cause permanent hearing loss after listening at
maximum volume levels for several hours.
I W
NSTALLATION
Before disassembling your beautiful new car you need some basic installation knowledge and skill with common hand and
power tools. Following such basic installation tips and warnings will prevent poss ble damage to the vehicle and also
prevent possible fires.
AGAIN...READ THE MANUAL!
will save time and prevent problems later.
COVER THE VEHICLE WORK AREAS
work areas from scratches or dings.
DISCONNECT THE (-) LEAD ON THE BATTERY
"REVIEW" THE INSTALLATION
components, take five minutes to review the installation intentions (e.g., verify that an
amplifier will fit in an area of a car before tearing out all the interior).
"REVIEW" THE VEHICLE
sure there are no fuel or hydraulic lines behind the surfaces. Also make sure there are no
wires routed directly behind or near the desired mounting area (remember...screws can
often extend 1-2 inches behind the mounting surface).
ENSURE PROPER FIT
fit in its desired location. Check for clearance around rear deck torsion bars or other
structural elements.
EVERY CAR IS ASSEMBLED DIFFERENT
assembly techniques. Take care in removing/modifying all trim panels and mounting surfaces since they often use
unique screws or snap fasteners that are difficult to replace if they are lost or broken.
BE CAREFUL WITH CABLE ROUTING
routed away from high current power lines for audio amplifiers and vehicle systems lines when possible. This will
help prevent noises from creeping into the audio system, plus prevent potential damage to the vehicle wiring itself.
BE CAREFUL WITH ALL CONNECTIONS
and properly secured. Observe all polarity markings carefully to ensure proper end performance.
CAUTION - FUEL TANKS AND FUEL LINES ARE NOW LOCATED DIRECTLY BENEATH THE REAR
DECK IN MANY CARS - CHECK FOR ADEQUATE CLEARANCE BEFORE EVEN CONSIDERING
SUCH A MOUNTING LOCATION!
Understanding the product and installation limitations before
- Always disconnect the negative battery cable before
- Rushing to complete an installation nearly always ends up with problems.
!
ARNINGS
There is a lot of helpful information in this manual that
- Use fender covers or blankets to protect the
- Before using any tools or moving vehicle
- Before drilling any holes or cutting into any surfaces, make
- Before cutting or drilling, make sure the amplifier will physically
- When routing audio cables, make sure RCA and speaker wires are
- Flying debris are always dangerous.
- No sparks or fires please!
- Every auto manufacturer uses different
- When making connections, make sure each connection is clean
– 3 –
- these amplifiers, used with high