Blaupunkt ProComponent PCA 250 Manual De Uso página 2

B S
LAUPUNKT PECIFICATIONS
Below is a basic trouble-shooting guide to assist in seeking out and correcting a problem that may occur in the installation
process. Although lengthy, this chart cannot address every single problem poss ble but mainly the ones most common.
PARAMETER/FEATURE
Channels
Size ( W x H x D)
Weight (with housing)
Spade screw speaker terminals?
Maximum terminal wire size
Subsonic filter
Separate front/rear or left/right gains?
Fuse Type
Speaker short, short to +12V, and short to ground protection?
High, low, and reverse voltage protection?
Power output transistors
Switching power supply transistors
Minimum speaker impedance
PERFORMANCE DATA
Rated power output @ 0.1% THD, 14.4V
2 channels into 4 ohms / 2 ohms
1 channel into 4 ohms
Total Harmonic Distortion @ rated full output
Rated Signal/Noise ratio (averaged value)
Measured @ 1 watt / 1 kHz
Measured @ full rated power (0.1% THD) dBA
Damping factor
Frequency response (full-range mode)
High-pass crossover frequency limits
Low-pass crossover frequency limits
Input impedance
Input signal voltage control range
Current Draw @ 13.8 VDC (typical values @ X watts / Efficiency %)
@ full rated power, unbridged
@ 33% rated power, unbridged
@ idle
Minimum battery voltage to maintain rated power
Usable battery voltage
Trigger line voltage range
Trigger line current draw
Turn on delay time
Thermal shutoff temperature (average heat-sink temp)
NOTE: DUE TO ONGOING PRODUCT IMPROVEMENTS, DESIGN AND SPECIFICATIONS ARE SUBJECT TO CHANGE
WITHOUT ADVANCED NOTICE TO THE CONSUMER OR RETAILER.
-
PCA 250
AND
PCA 250
2/1
9.2x2.0x9.5 inches (234x51x241mm)
3.5 lbs (1.59 kg)
YES
14 ga.
YES (10 Hz)
NO
ATC spade -20A
YES
YES
BTL
BTL
(non-bridged) 2 ohms
(bridged) 4 ohms
(watts rms) 2 x 50 W / 2 x 75 W
(watts rms) 1 x 150 W
0.1% THD
dBA 85
>100
>100
20 - 30,000 Hz
50 H z - 250 Hz (variable), 12dB/oct
50 H z - 250 Hz (variable), 12dB/oct
10 kohms
0.3 - 6.0 vrms
(@ 4 ohms) 13.3 A (50%)
(@ 4 ohms) 7.5 A (35%)
(@ 4 ohms) 1.5 A
12.6 VDC
10 - 16 VDC
10 - 16 VDC
< 10 mA
@ 2.0 seconds
@ 85˚ C (185˚ F)
PCA 2100, 2/1 C
PCA 2100
2/1
9.2x2.0x12.6 (234x51x320mm)
4.8 lbs (2.18 kg)
YES
14 ga.
YES (10 Hz)
NO
ATC spade -Two 20A
YES
YES
BTL
BTL
2 ohms
4 ohms
2 x 100 W / 2 x 150 W
1 x 300 W
0.1% THD
85
>100
>100
20 - 30,000 Hz
50 H z - 250 Hz (variable), 12dB/oct
50 H z - 250 Hz (variable), 12dB/oct
10 kohms
0.3 - 6.0 vrms
26 A (52%)
15 A (50%)
1.5 A
12.6 VDC
10 - 16 VDC
10 - 16 VDC
< 10 mA
@ 2.0 seconds
@ 85˚ C (185˚ F)
A
HANNEL MPLIFIER