Battery Installation
• Locate the battery door on the bottom of the toy (A).
• Slide the battery door in direction of the arrow (A).
• Lift up the battery door to remove.
• Insert 3, AA batteries into the battery compartment (B).
• Replace the battery door and ensure it is closed properly.
Operating Instructions
Toy Assembly
• The canary sits on top of the spring arm.
• Attach the spring arm to the connector nub on the top of the ball by twisting the
spring arm until it is fully connected (C).
One-Time-Play Mode
• Press and release the power button
• The toy will chirp to indicate that a single play session has been activated.
• The toy will automatically turn off after 10-15 minutes.
• If you wish to end the play session before the toy automatically turns off, press
and release the power button
"Play-While-You-Are-Away" Mode
Observe your cat playing with the toy before you enable the "Play-While-You-
Are-Away" mode. Make sure your cat can safely play with the toy in this mode,
and that the toy is working properly before leaving your cat alone.
• To activate multiple play sessions throughout the day; start with the toy off,
press and hold the power button
beeps indicate the toy will cycle through 3 play sessions.
• The next play session will begin 2 hours after the first play session ends. The
toy will chirp at the beginning of second play session. The final play session
will begin two hours after the second play session has finished.
• Each play session will last 10-15 minutes. The time between sessions is 2 hours.
• The total "Play-While-You-Are-Away" period is 4.5 hours.
• If you wish to turn off the toy, press the power button
then release.
located on side of the toy to turn on power.
once.
until the toy beeps 2 times. The audible
for 1 second,
• Each time the "Play-While-You-Are-Away" mode is activated, and prior to
leaving your cat unsupervised with the toy, ensure that the toy is in a safe
location for your cat to play.
The "Play-While-You-Are-Away" mode should be used at the owner's discretion.
To Ensure Proper Function
• Do not mix old and new batteries.
• Only use batteries of the same or equivalent type as recommended.
• Do not mix standard alkaline or rechargeable batteries.
• Exhausted batteries should be removed immediately.
Important Recycling Advice
Please respect the Waste Electrical and Electronic Equipment regulations in
your country. This equipment must be recycled. If you no longer require this
equipment, do not place it in the normal municipal waste system. Please
return it to where it was purchased in order that it can be placed in our recycling
system. If this is not possible, please contact the Customer Care Centre for further
information. For a listing of Customer Care Centre telephone numbers, visit our
website at www.FroliCat.com.
Compliance
This equipment has been tested and found to comply with the EU
Electromagnetic Compatibility. Unauthorised changes or modifications
to the equipment that are not approved by Radio Systems Corporation could void
the user's authority to operate the equipment, and void the warranty. This product
is in compliance with the provisions of the EMC directives. The Declaration of
Conformity documents can be found at:
www.FroliCat.com/declarations-of-conformity.
3