19
PRODUCT CARE
To guarantee that your child seat provides the maximum protection, it is essential
to comply with the following points:
All visible parts of the child seat must be regularly checked for damage. The
mechanical parts must function faultlessly.
It is essential to make sure that the child seat is not jammed between hard
parts such as the car door, seat rails etc., which can damage it.
If the child seat is dropped it must be tested by the manufacturer before being
used again.
CLEANING
Care must be taken that only an Original CYBEX Seat Cover is used, because
the cover is also a fundamental component of the good functioning of the child
seat. Replacement covers may be obtained from a specialist shop.
NOTE! PLEASE WASH THE COVER BEFORE USING IT FOR THE FIRST
TIME. THE COVER SHOULD BE WASHED AT 30 °C IN A DELICATE
WASH CYCLE. WASHING IT AT TEMPERATURES HIGHER THAN 30 °C
MAY RESULT IN THE COLOURS RUNNING. WASH SEPARATELY FROM
OTHER ITEMS AND NEVER DRY IN THE TUMBLE DRYER! NEVER DRY IN
STRONG SUNLIGHT! THE PLASTIC PARTS CAN BE CLEANED WITH A MILD
CLEANING AGENT.
!
Warning! Never use chemical cleaning or bleaching agents!
REMOVING THE SEAT COVER
The cover consists of three main components for headrest, backrest and seat
cushion, which are secured to the child seat either by velcro, press-studs or
elastic bands. Once you have released all the fastenings, you can remove the
individual components for washing.
To detach the individual components of the cover carry out the following steps:
Once the press-studs on the back of the backrest have been undone, the
cover can be removed by drawing it forwards.
To remove the seat cushion cover, release both belt straps and also undo the
press-studs on the underside and draw the cover forward.
The headrest cover can simply be pulled forward to remove it.
To replace the cover, carry out the same steps in the reverse order.
Capítulos
