Information About Electric Griddle Plates Optima Series; Laws, Regulations And Technical Directives; Installation Place; Positioning - Diamond OPTIMA 700 Instrucciones Para La Instalación, El Uso Y El Mantenimiento

Idiomas disponibles
  • ES

Idiomas disponibles

2.1

INFORMATION ABOUT ELECTRIC GRIDDLE PLATES OPTIMA SERIES

The technical serial plate is affixed inside the
unit, beneath the front panel.
2.2

LAWS, REGULATIONS AND TECHNICAL DIRECTIVES

The following indications should be observed during installation:
- Accident and fire regulations in force
- The regulations of the electric power supply company.
- Hygienic regulations.
- The rules for electrical systems.
2.3

INSTALLATION PLACE

- The unit should be installed in adequately ventilated places.
- Install the unit in compliance with the safety regulations.
2.4

POSITIONING

- The various units may be installed individually or together with other units of our range.
- This unit is not suitable for encasing.
- The distance between side walls must be a minimum of 10cm; should the distance be less or the wall or floor material be
flammable, it is essential to use a thermal insulator.
2.5

MOUNTING THE TOP UNITS ON A BASE OR AN EXTENDING SUPPORT

All Top units are supplied with height-adjustable feet (P):
- When the unit is to be placed free on a table or a surface,
tighten or loosen the feet (P) as shown in the illustration
till it is perfectly steady, then tighten the locknut (D) so
that the foot is blocked. To prevent slipping, insert the
rubber plugs (M) into the feet's lower holes.
- When the unit is to be fixed to a base or an extending
support, adjust the feet (P) till it is perfectly steady,
then tighten the locknut (D) so that the foot is blocked.
Subsequently fasten from beneath by way of M5 screws
(T) and respective washers, screwing them into the feet
as shown in the illustration.
MBM BRESCELLO - ITALY
RE37187/1998
V
KW
- 12 -
Mod.
Matr. N°
HZ
loading