Before You Begin; Tools And Parts Needed; Parts Included; Preparing Fitted Units - Gaggenau VL 200 120 Instrucciones De Instalación

en-us

Before you begin

Before you begin
T ools and parts needed
B e f o r e y o u b e g i n
Phillips Head Screwdriver
▯
Pencil
▯
Drill with ¼" (6 mm) bit
▯
Jigsaw
▯
Tape Measure
▯
Note: Additional materials may be necessary for
installation in solid surface countertops. Contact the
countertop manufacturer.

Parts included

8

Preparing fitted units

Fitted units must be heat-resistant up to 90 °C. The
stability of the fitted unit must be guaranteed even after the cut-outs have been made.
Make the cut-out in the worktop for one or more Vario
appliances in accordance with the installation drawing.
The angle between the cut surface and the worktop must
be 90°.
After making the cut-outs, remove any shavings. Seal cut
surfaces with heat-resistant material.
Observe the minimum clearance of 10 mm between the
bottom of the appliance and unit parts.
When installing multiple Vario appliances: Remember to
take the space required for the VV 200 010/020
connection strip between the appliances into account.
The appliances can also be installed in individual
cutouts, keeping a minimum clearance of 40 mm between
them.

Appliance dimensions