Charging The Transmitter - Medtronic MiniLink REAL-Time Manual Del Usaurio

3 Slide the cover back on the charger until it clicks into place (as shown).

Charging the transmitter

Before using the transmitter for the first time, you must fully charge the transmitter
battery. This may take up to eight hours. It is recommended to recharge the
transmitter after each sensor use. A fully charged transmitter works at least 14 days
without recharging. A depleted transmitter can take up to two hours to recharge.
To charge the transmitter:
1 If the green light on the transmitter is lit or flashing, do not
connect it to the charger. The transmitter will not charge
with its green light on. Wait until the green light turns off
(approximately 30 seconds), and then connect the
transmitter to the charger.
2 Connect the transmitter to the charger by lining it up, flat
side down, with the charger. Push the two components
together fully.
3 Within 10 seconds after the transmitter is connected, a
green light on the charger will flash for one to two seconds
as the charger powers on. For the rest of the charging time,
the charger's green light will continue to flash in a pattern of
four flashes with a pause between the four flashes.
4 When charging is complete, the green light on the charger
will stay on, without flashing, for 15 to 20 seconds and then
turn off.
5 After the green charger light turns off, disconnect the transmitter from the
charger. The green light on the transmitter will flash for about five seconds and
then turn off.
-5-